2point
07/31/2006, 05:24 PM
Lets start some tunning talk here.
I have K-pro with the newest software DL'ed from hondata and am looking for more people that have this wonderfull piece of electronics.
Here are my mods and I have a couple K-pro calibrations if anyone wants them > just email me at pwrslide2@yahoo.com
Stock K20a2 w/6spd
Fidanza Lightweight flywheel
short ram intake
R-crew race header - Same as sparks 4-2-1 & has 2.5" collector
2.5" exhaust < ghetto prolly pinches to 2.25" at one of the bends
I only run the primary O2 sensor
NO PS
NO AC
I have a really stock mapped used for just an intake.
I also have another that is for a intake + header + exh and this one has a lot of work done on it < a dyno tuned graph with cam angle changes and all. Runs well with no knock but I do have a 2.5" high flow cat in place. I haven't done any datalogs with it yet without a cat. Have not experience knock with it. I have not had a dyno run with it either.
I have K-pro with the newest software DL'ed from hondata and am looking for more people that have this wonderfull piece of electronics.
Here are my mods and I have a couple K-pro calibrations if anyone wants them > just email me at pwrslide2@yahoo.com
Stock K20a2 w/6spd
Fidanza Lightweight flywheel
short ram intake
R-crew race header - Same as sparks 4-2-1 & has 2.5" collector
2.5" exhaust < ghetto prolly pinches to 2.25" at one of the bends
I only run the primary O2 sensor
NO PS
NO AC
I have a really stock mapped used for just an intake.
I also have another that is for a intake + header + exh and this one has a lot of work done on it < a dyno tuned graph with cam angle changes and all. Runs well with no knock but I do have a 2.5" high flow cat in place. I haven't done any datalogs with it yet without a cat. Have not experience knock with it. I have not had a dyno run with it either.